Now you can own a NEW FM stereo transmitter without spending a fortune.  This unit has front panel meters to monitor your deviation for easy setup and a Amperage meter to monitor the current drain.   The audio response is 20 Hz to over 15 KHz.  Believe me, this unit sounds just like the big stations!  Excellent base and highs!!!  Power adjustment can be made smoothly from under 100 milliwatts to 25 watts using the back panel power level control and was designed for a the 87.50 to 108.00 MHz which makes it excellent FM stereo transmitter or exciter for  a high power amplifier!  

The unit is powered from 120 or 220 volts AC at 50 or 60 Hz.

Its highly accurate crystal reference and PLL circuitry ensures you will have a very stable signal at all times.   The frequencies can easily be selected by pressing the set button and up down arrow keys.  The frequency range is of this model is 84.00 to 95.80 MHz and the channel resolution is 10KHz.  We can also factory preset the unit to your desired frequency.  No internal adjustments are necessary since the unit uses a wideband amplifier that does not require any tuning!  

The chart below shows the maximum power output at various frequencies for a transmitter ordered for a center frequency of 88.3 MHz.  The transmitter can be set to other frequencies not on the chart as long as the frequency falls within 84.10 to 95.80 MHz.  Power between the frequencies in the chart can be approximated since we did not measure the output of all frequencies.

We can have the transmitter peaked up at your desired operating frequency in the 87.5 to 108 MHz range so you will have maximum power.  You will also be able to change the frequency up or down around 6 MHz.  Please allow 2-4 weeks for shipping since each unit is customized for peak power output on your desired operating frequency.

The amazing sound quality is due to the well engineered Phase lock loop, (PLL) circuitry that  allows even very low audio  frequencies to fully modulate the transmitter without attenuation!  

2 RCA input CD jacks  and 2 RCA input AUX jacks enable stereo audio feed on the back panel.  The audio level is adjusted by the front panel control knobs and is easy to set to 100% modulation with a wide range of audio input levels.   High audio input impedances enable the use of almost any type of audio source.  Other transmitters can often load down the audio source which usually results in the loss of high frequency response.  You will not have to worry about high frequency loss with this transmitter!  There is also a 1/4" microphone input jack on the back and a front panel mic level control on the front panel for live broadcasting voice.

The unit is housed in a very nice aluminium enclosure that shields the unit.  A good enclosure can often prevent feedback problems if using an additional amplifier for even more power.  For long range a high gain antenna could be used and connected to the standard SO-239 connector on the back of the unit.  We can also help you out getting set up with an antenna.

If you are seriously looking for a high performance Stereo transmitter, this is definitely the one!   

Shipping info

US Shipping: cost is $65 by Xpresspost insured to all continental US destinations.  This is a 4-5 business day service.  We can also ship to any contenental US destination by Expedited post for $45.  This is a 7-10 day service but the time in transit is not guaranteed by the post office. Claims for this service cannot be processed sooner than 30 days after the ship date.

International shipping: cost is $95 by insured Xpresspost 5-7 business days to most destinations.  This is a traceable service.  Alternatively we can ship by insured Surface air mail for $70 to most international destinations.  This will normally take 4-5 weeks but is not traceable.  If lost, insurance claims for this service cannot be made sooner than 90 days after the ship date.  We can insure the shipment to most countries by these postal services.